MA6300 Integrated Amplifiers

With 100 watts per channel at 8 ohms and 160 watts into 4 ohm loads, the MA6300 can effortlessly power virtually any speaker from one of seven source selections: CD1, CD2, Tuner, Phono, Tape, TV and DVD


With 100 watts per channel at 8 ohms and 160 watts into 4 ohm loads, the MA6300 can effortlessly power virtually any speaker from one of seven source selections: CD1, CD2, Tuner, Phono, Tape, TV and DVD. Featured in the MA6300 is a dedicated, high performance headphone amplifier boasting low noise, extended frequency response and featuring ample gain to drive finest quality headphones to life-like levels.

SPECIFICATIONS
POWER OUTPUT
100 watts into an 8 ohm load is the minimum sine wave continuous average power output. The output RMS voltage is 28.3V across 8 ohms.
160 watts into a 4 ohm load is the minimum sine wave continuous average power output. The output RMS voltage is 25.3V across 4 ohms.
OUTPUT LOAD IMPEDANCE: 8 and 4 ohms
RATED POWER BAND: 20Hz to 20kHz
TOTAL HARMONIC DISTORTION
0.005% max harmonic distortion at any power level from 250 milliwatts to rated power, 20Hz to 20kHz
DYNAMIC HEADROOM: 1.4dB
FREQUENCY RESPONSE
+0, -0.5dB from 20Hz to 20kHz
+0, -3dB from 10Hz to 100kHz
PREAMPLIFIER MAIN OUTPUT
1V for rated input (8V maximum)
SENSITIVITY (FOR RATED OUTPUT)
High level: 250mV unbalanced, 500mV Balanced; Phono: 2.5mV; Power Amp In, 1V
SIGNAL-TO-NOISE RATIO (A-Weighted)
High Level: 97dB below rated output
Phono: 90dB below 10mV input
Power Amplifier: 110 below rated output
INTERMODULATION DISTORTION
0.005% max, if the instantaneous peak power output is rated power or less per channel with both channels operating for any combination of frequencies from 20Hz to 20kHz
WIDE BAND DAMPING FACTOR:
200 at 8 ohms; 100 at 4 ohms
INPUT IMPEDANCE:
High Level: 20K ohms; Phono: 47K ohms: 65pF; Power Amp In: 10K ohms
MAXIMUM INPTU SIGNAL
High Level: 8V; Phono: 90mV; Power Amplifier In: 8V
MAIN OUTPUT IMPEADANCE: 50 ohms
POWER GUARD:
Less than 2% THD with up to 16dB overdrive at 1000Hz
VOLTAGE GAIN:
High Level to Tape Output: 0dB
High Level to Main Output: 12dB
Phono to Main Output: 52dB
POWER REQUIREMENTS:
100/110 Volts, 50/60Hz at 3.6 amps
120 Volts, 50/60Hz at 3.2 amps
220/230/240 Volts, 50/60Hz at 1.8 amps
OVERALL DIMENSTIONS (HxWxD):
7-5/8” (19.4cm) x 17-1/2” (44.5cm) x 22” (55.9cm) ) including front panel and knobs.
WEIGHT:
37 lbs. (16.8kg) net, 55 lbs. (24.9kg) boxed

Shipping and delivery:


To know delivery time and delivery cost please contact us at the number below:
+39 0142 418955 or please send us an e-mail: customer.service@bensotech.it